期刊


ISSN0954-4054
刊名Proceedings of the Institution of Mechanical Engineers
参考译名机械工程师学会会报B辑:工程制造杂志
收藏年代1995~2024



全部

1995 1996 1997 1998 1999 2000
2001 2002 2003 2004 2005 2006
2007 2008 2009 2010 2011 2012
2013 2014 2015 2016 2017 2018
2019 2020 2021 2022 2023 2024

2011, vol.225, no.1 2011, vol.225, no.10 2011, vol.225, no.11 2011, vol.225, no.12 2011, vol.225, no.2 2011, vol.225, no.3
2011, vol.225, no.4 2011, vol.225, no.5 2011, vol.225, no.6 2011, vol.225, no.7 2011, vol.225, no.8 2011, vol.225, no.9

题名作者出版年年卷期
Review of variational models for tolerance analysis of an assemblyM. Marziale; W. Polini20112011, vol.225, no.3
An analytical model for top width of jet footprint in abrasive waterjet milling: a case study on SiC ceramicsD. S. Srinivasu; D. Axinte20112011, vol.225, no.3
Machining capacity measurement of an industrial product service system for turning processQ. Q. Zhu; P. Y. Jiang20112011, vol.225, no.3
Analysis of the thickness distribution varying tool trajectory in single-point incremental formingL. Manco; L. Filice; G. Ambrogio20112011, vol.225, no.3
Failure criterion for aluminium tubes during warm hydroforming and in crash applicationsY. S. Lee; H. K. Yi; C. J. Van Tyne; Y. H. Moon20112011, vol.225, no.3
Springback correction of stamped, curved U-channel part by laser bendingH. B. Shim; K. H. Kim20112011, vol.225, no.3
An investigation into the effect of die temperature and heat treatment on A360 properties produced by the semi-solid forming and cooling slope methodM. M. Keikha; M. Safari; S. Heisiattalab; V. Arbabi20112011, vol.225, no.3
Development and performance estimation of an exhaust gas recirculation cooler with dimpled rectangular tubesY.-H. Seo; S.-C. Heo; T.-W. Ku; J. Kim; B.-S. Kang20112011, vol.225, no.3
Flow drilling and thread forming of continuously reinforced aluminium extrusionsT. Engbert; T. Heymann; D. Biermann; A. Zabel20112011, vol.225, no.3
Numerical study on the effect of the frequency and amplitude of the tool on the material removal rate in ultrasonic-assisted electrical discharge machiningM. T. Shervani-Tabar; M. R. Shabgard20112011, vol.225, no.3
12