期刊


ISSN0043-1648
刊名Wear
参考译名磨损
收藏年代1997~2024



全部

1997 1998 1999 2000 2001 2002
2003 2004 2005 2006 2007 2008
2009 2010 2011 2012 2013 2014
2015 2016 2017 2018 2019 2020
2021 2022 2023 2024

1998, vol.214, no.1 1998, vol.214, no.2 1998, vol.215, no.1-2 1998, vol.216, no.1 1998, vol.216, no.2 1998, vol.217, no.1
1998, vol.217, no.2 1998, vol.218, no.1 1998, vol.218, no.2 1998, vol.219, no.1 1998, vol.219, no.2 1998, vol.220, no.1
1998, vol.220, no.2 1998, vol.221, no.1 1998, vol.221, no.2 1998, vol.222, no.1 1998, vol.222, no.2 1998, vol.223, no.1-2

题名作者出版年年卷期
A method of modeling residual stresses in superfinish hard turningS. Mittal; C. R. Liu19981998, vol.218, no.1
Comparison of tribological characteristics of sputtered MoS{sub}2 films coated with different apparatusM. Suzuki19981998, vol.218, no.1
Cyclic variations in friction forces and contact stresses during fretting fatigueJ. Dominguez19981998, vol.218, no.1
Effect of chemical structure of rogano-chorine compounds on the lubricity of Al2024 against steelY. Hu; W. Liu19981998, vol.218, no.1
Effect of machined surface condition on the repeated impact behavior of silicon nitrideE. S. Zanoria; P. J. Blau19981998, vol.218, no.1
Evaluation of thermally-sprayed ceramic coatings using a novel ball-on-inclined plane scratch methodY. Wang; S. M. Hsu; P. Jones19981998, vol.218, no.1
Grinding of single crystal sapphire: workpiece roughness correlationsP. D. Funkenbusch; Y. Zhou; T. Takahashi; D. Golini19981998, vol.218, no.1
Influence of the critical cutting speed on the surface finish of turned steelP. Munoz-Escalona; Z. Cassier19981998, vol.218, no.1
Investigation of the temperature effects on induced impact pressure and cavitation erosionS. M. Ahmed19981998, vol.218, no.1
sliding wear characteristics of low temperature plasma nitrided 316 austenitic stainless steelY. Sun; T. Bell19981998, vol.218, no.1
12